Material valuation tests of the CSR (Solid Recovered Fuel) of the Artigas TMB Doc Title: Material valuation tests of the CSR (Solid Recovered Fuel) of the Artigas TMB Contract Type: services

The subject of the order is to provide testing services for samples of liquid fuels (diesel oil, E-5, E-10 gasoline) as part of the fuel quality monitoring and control system implemented by the President of the Office of Competition and Consumer Protection using Trade Inspection pursuant to the Act of August 25, 2006 on the fuel quality monitoring and control system (Journal of Laws of 2024, item 1209, as amended). A detailed description of the subject of the order can be found in Annex No. 1 to the Specification of Conditions Orders (SWZ) - "Description of the subject of the order", hereinafter referred to as "OPZ". Testing samples of liquid fuels (diesel oil, E5 and E10 motor gasoline) as part of the fuel quality monitoring and control system The subject of the order is the provision of services testing samples of liquid fuels (diesel oil, E-5, E-10 gasoline) as part of the fuel quality monitoring and control system implemented by the President of the Office of Competition and Consumer Protection through the Trade Inspection pursuant to the Act of 25 August 2006 on the fuel quality monitoring and control system (Journal of Laws of 2024, item 1209, as amended). The Ordering Party reserves the right to grant renewal. The renewal should not exceed 100% of the subject of the basic order, i.e. services specified in the subject scope presented above. Detailed rules regarding the resumption are described in the draft provisions of the agreement. A detailed description of the subject of the order can be found in Annex No. 1...

Single-stage negotiation process in accordance with Section 151 BVergG 2018 in the sub-threshold area for scientific support as well as curation and production of an exhibition. For more information, see tender documents. Scientific support and curation and Production of an exhibition The subject of the award procedure is the scientific support as well as the curation and production of an exhibition. The exhibition deals with the history of security administration in the BMI (period: 1848 until today), the history of the security executive in Austria (period: 1849 to today) as well as the interaction of security administration and security executive with civil society phenomena (implementation of a museum of the interior - history and presence of the BMI and the police). Doc Title: Museum of the Interior - History and Present of the BMI and the Police Contract Type: services

The services entrusted to the holder will be analog and mixed block layout services. These blocks will be described in the form of annotated diagrams available in a Cadence database when the task starts. A circuit database integrated brings together all the diagrams constituting the circuit, organized hierarchically. The physical implementation of these diagrams will be done in several stages and at several granularities. They can be described as follows: Layout of a block diagram : -Analysis of the diagram: oIdentification of sensitive points, topological constraints, implementation precautions to take oProposal of a floorplan of the block and evaluation of the surface area -Creation of the layout: oPlacement and connection of components oProposal for minor modification to the diagram if relevant -Carrying out checks: oDRC oLVS At the end of the layout steps, schematic views integrating the parasitic elements induced by the physical implementation are extracted and simulated. by CEA designers to validate the suitability of the layout with the expected performance. In the event of insufficient performance, a rework for optimization of the layout may be requested. Layout for assembling blocks together into macro-blocks: the steps are substantially the same as for unit blocks (analysis, layout, verifications), but at a higher level of hierarchy. The complexity of these assemblies depends on the number of interface signals, co...

As part of the Pact for Research and Innovation, the federal and state governments have agreed to give science and research organizations financial planning security through a reliable annual increase in their donations. The pact partners have In the new edition, the Pact for Research and Innovation IV (PFI IV), in return they agreed on five central research policy goals that are to be achieved with the pact: 1. Promote dynamic development 2. Transfer into business and Strengthen society 3. Deepen networking 4. Attract and retain the best minds 5. Strengthen infrastructure for research The pursuit of research policy goals has been carried out in the PFI monitoring reports published once a year since 2007 presented and evaluated. To create the monitoring reports, among other things: various qualitative and quantitative indicators were collected from science and research organizations and their annual development was documented. Goal of this The advertised service contract is to be carried out as part of the PFI monitoring report by the four major non-university research organizations (Fraunhofer Society, Helmholtz Association, Leibniz Association and Max Planck Society) to supplement the key figures collected with independently determined data on publications and conference contributions along four central research policy goals (No. 1-4 in the list above). For this purpose, bibliometric reports should be carried out annually Indicators are collected, analyzed and interpreted, which on the one hand complement the PFI monitoring reports as independent bibliometric reports, and on the other hand also provide material that is included in short form as illustrative information in the annual PFI monitoring reports can be found. Research and development services and related consultancy services (CPV code: 73000000)

4 impact tests on a railing end that complies with RiZ-ING GEL 19. The design of the railing and the railing end are carried out according to specifications. The same applies to the installation and construction of the foundation. A total of four attempts will be carried out Based on the standards DIN EN 12767 and DIN EN 1317, the test item is carried out. The individual tests are listed in Table 1 of the service description. At the time of the tender or award, only experiment 1 is complete set. The exact determination of experiments 2-4 is made after the previous experiment, based on its results. Therefore, when scheduling the experiments, a time buffer of at least four weeks must be planned between the experiments. For the For the parameters impact, vehicle mass, angle and speed, a framework is specified for tests 2-4 in which the tests should take place. If the standard DIN EN 1317 is mentioned below, this refers to, unless otherwise stated the parts DIN EN 1317-1:2011-01, DIN EN 1317-2:2011-01, DIN EN 1317-3:2011-01 and DIN CEN/TS 1317-7:2024-04. DIN EN 12767 refers to the version DIN EN 12767:2025-03. The contractor is responsible for the technical implementation and a Sufficient and comprehensive documentation and evaluation of the tests based on DIN EN 12767 and DIN EN 1317. Taking into account the requirements of the current test standards, the contractor records, determines and documents on his own responsibility all necessary data (including suitable film recordings) to show the behavior of the vehicles and the test object in the entire relevant test area with all relevant details (e.g. parts of the object becoming detached) in all phases of the impact process to be able to describe and assess completely (i.e. with sufficient space, for example). Research and experimental development services (CPV code: 73100000)

Brief description of the tender: The Ministry of Social Affairs is commissioning a feasibility study for an intervention aimed at children with anxiety disorders and their families. The feasibility study of the piloted intervention evaluates the feasibility of the intervention in Estonia, evaluates the impact of the intervention on children and theirs families and, if necessary, makes changes/additions so that the intervention better meets Estonian conditions.

Analog and mixed integrated circuit layout services

The Copernicus Data Space Ecosystem (CDSE) continues to expand its portfolio by onboarding new, high value Earth observation data that further strengthen the platform-s scientific, operational, and analytical capabilities. Within this context, the objective of this procurement is to ensure the full integration of three additional families of datasets into the CDSE, building on its open, cloud based, and extensible architecture. The scope of the activity covers the complete end to end onboarding lifecycle, including data preparation, automated ingestion, metadata extraction and harmonisation, catalogue publication, and access enablement through scalable and standardised interfaces. All onboarded content shall be made discoverable and accessible via the existing CDSE catalogue services, ensuring consistency, traceability, and interoperability with the broader service data offer. The activity will further enhance user experience across the ecosystem by enabling thematic visualisation capabilities, detailed data exploration features, and advanced data processing capabilities. Interoperability and alignment with existing CDSE components are key elements of the scope. The selected Contractors shall contribute to the harmonisation of data models, catalogue structures, and service interfaces, ensuring compliance with CDSE operational set-up. Close coordination with CDSE engineering teams will be required to ensure that onboarding solutions are reusable, maintainable, and extensibl...

This contract aims to develop activity 2.1 Tender for flight operations, the development of data processing applications and the management of the AGAMENON project, so its purpose is the contracting a service comprehensive flight operations of medium and/or high altitude UAS platforms and persistent flight, with on-board sensors, as well as the development of data processing applications, necessary to carry out part of the activities committed by PTFSA in the project to Support the Management of the Immigration of Unaccompanied Minors through early detection systems. Specifically, the execution by PTFSA of part of the commitments acquired by said entity, counting on the infrastructure of PTFSA Canarias Stratoport for HAPS&UAS located in Fuerteventura. In addition, the ISSEC center will be available for data collection and dumping. Deployment of operations with medium and/or high altitude UAS platforms (HAPS/MAPS) and development of the data management applications within the framework of the AGAMENON project This contract aims to develop activity 2.1 Tender for flight operations, development of data processing applications and project management AGAMEMNON, so its object is contracting a comprehensive flight operations service for medium and/or high altitude UAS platforms and persistent flight, with on-board sensors, as well as the development...